Monday 29 September 2014

Almost done.

The spinning wheel tuning is almost finished - I had planned to do the remainder of the work, not easily done in the FabLab, yesterday, but then a large-scale cooking session got into the way of that plan.

All that remains to do, however, is glue the parts of the flyer together and then test if the setup works well enough for a good, long test-run. I might have to make a new holder for the flyer, too, but for the moment there's a temporary contraption on the wheel consisting of the old holder and an array of clamps holding it in its new, better-aligned place.

So. Ten minutes for this glue batch to set, then I'll glue the next one. Then the wooden parts need to be fixed, permanently, to the metal axle. And then comes the moment of truth.

Hopefully it will all work out as planned!

No comments: